Creative Solutions Since 1982

GE Low Voltage Light Switch RS239 - Gray

Item #:
No reviews yet Write a Review
Usually ships in 1-2 business days.
Design Preview
This image reflects design only, not finish.


Flat Rate Shipping on any size order*

  • Ships Fast
  • No Minimum Order
  • 30 Day Returns
  • No Restocking Fees
*Learn More


Replace your old rocker switches with new General Electric grey and black low voltage switches. Replacement 3 amp 24 volt A.C. gray low voltage light switch with on/off buttons for 1950s, 1960s and 1970s era homes with low voltage lighting systems installed. Unlighted devices are the replacements for original GE RFS-6, RFS-3, and RFS-9 switches. 


Gray Alternative: Gray Low Voltage Despard Switches and wall plates.


  • IMPORTANT: Fits in GE new style and bracket mount switchplates ONLY. Does not fit old style covers or straps.
  • 3A 24 V.A.C. (volt alternating current)
  • may use as single pole or 3 way switch - see GE Switch Wiring Instructions for 3-way installations
  • one button is for turning on light; the other for turning it off - marked on side
  • SPDT momentary manual override switch
  • standard Class 2 control relay wiring
  • five 0.187" quick disconnect terminals included (3 needed for connecting plus 2 extras)
  • fits .76" x 1.28" rectangular switch cover opening
  • replaces GE RFS3, RFS6 and RFS9 rocker devices as well as similar-looking Bryant switches
  • slightly larger than original RFS series switches so new wall plates required
  • made in USA by General Electric
  • UL listed

Need more components for GE low volt? Shop GE and Bryant Switches, Switch Plates, Relays and Transformers.

Q & A

My original low voltage Bryant light switches are installed in a strap. Do these new switches require a strap?
No, these new switches snap right into the front of New Style Light Switch Covers so that no strap is required (unless using with Bracket Mount Wall Plates). The small wings on the sides of the switches will spring out once snapped into place and hold them in position.

I have three older low voltage switches in a bracket but one of them isn't working. Can I just replace the broken one with a new switch?
No. Do not install a new switch in a vintage strap. New switches are a bit larger than the old rocker switches and will be damaged if you try jamming them into your original bracket. In addition, the buttons can become stuck in the on or off position and burn out both the switch and the relay.

Related Products

Recently Viewed

Easy Shopping
No Minimum Order
Largest Selection
Quality Plates Made in USA
Prompt Shipping
Easy Returns