Creative Solutions Since 1982

Manual Controller Momentary Toggle Switch 24VDC 120VAC P&S 1250

Item #:
No reviews yet Write a Review
Usually ships in 1-2 business days.
Design Preview
This image reflects design only, not finish.


Flat Rate Shipping on any size order*

  • Ships Fast
  • No Minimum Order
  • 30 Day Returns
  • No Restocking Fees
*Learn More


Manual controller low voltage toggle switch replaces a 3-wire 24 volt low-voltage switch, such as those in a Remcon low voltage wiring system. These double throw center off (DTCO) switches are a good choice when trying to match your single-gang low voltage switches to the traditional look of toggles. Fits in any toggle switchplate opening. Switch makes temporary contact when flipped up or down then returns to the center position while it remains open (not in contact). Momentary controller switches change the state from on to off such as for lighting.


  • single pole, three position
  • can be wired for 3 amp 24VDC or 15A DC 120/277V applications
  • tested to 3 amps 24DC rating
  • oversize silver alloy contacts for long life and better heat dissipation
  • side wired terminals accept #14 - #10 AWG copper or copper-clad conductors
  • momentary switch with center off; normally open
  • single pole double throw (SPDT) or double pole double throw (DPDT)
  • commercial switch, solid feel 
  • side wired terminals accept #14 - #10 AWG copper or copper-clad conductors
  • neutral position is in middle (neither up or down - sticks straight out)
  • choose from white, ivory, or brown, by Pass & Seymour
  • can be mounted in standard device boxes or in NEMA 1 sheet steel enclosures
  • 1.469" deep x 3.281" high by 1.5" wide
  • made in Mexico, buy American compliant
  • UL and CSA listed

Find more low voltage lighting components.

Related Products

Easy Shopping
No Minimum Order
Largest Selection
Quality Plates Made in USA
Prompt Shipping
Easy Returns