Description
Hide exposed wall box with gap filler wall plate depth extender ring for Adorne light switch covers. Stack these 1/8" thick spacers under a Legrand Adorne wall plate to cover up a 1/4", 3/8" 1/2" or deeper wall box that is sticking out from the wall. This situation occurs with standard boxes on shallow walls, updated walls where paneling was removed, or electrical switches don't fit fully into shallow boxes. Fits around a single gang box fitted with an Adorne light switch, outlet, etc.
Features
- 4.84" high x 3.19" wide x 1/8" thick (4-27/32" x 3-3/16")
- stack multiple units to create extra depths - .25", .375", .5", .62", etc.
- inner opening 4.25" H x 2.31" W (4-1/4" x 2-5/16")
- adds border under single-gang Adorne device mounting panel up to fill gap
- fits around most electrical boxes - measure your box to ensure there is enough clearance
- held in place by friction when plate is installed over it
- note that Adorne plates have a reverse beveled edge so ring aligns with subplate
- Kyle Switch Plates exclusive item
- gloss acrylic, clean with warm water
- WARNING: for decorative use only. Ensure devices are properly installed in box. Important: if using with protruding devices, must use fire safety box extenders and spacers to ensure devices are safely installed
- for use on flat surfaces only; sand wall to remove bumps
- do not bend or item may crack
- white, black, or ivory hard plastic gaskets
- designed for use with 1-gang Adorne wall plates
- Adorne is a Pass & Seymour Legrand trademark
- American made
Uses
- Hide sides of standard electrical box in shallow wall
- Add an edge behind wall plate to hide bulky devices
