Description
Hide edges of 2-gang exposed wall box with a 2-gang gap filler wallplate depth extender for Radiant light plate covers. You may stack up these 1/8" thick spacers under a 2-gang Legrand Radiant wall plate to cover up gaps that are 1/4", 3/8" 1/2" or deeper when your electrical box is protruding from the wall. This may occur with standard depth boxes on shallow walls, remodeled rooms where paneling was taken out, or where electrical devices slightly sit above shallow boxes. Fits around a double gang box with a Radiant light switch, outlet, etc., installed.
Features
- 4.87" high x 5.0" wide x approximately 1/8" thick (4-7/8" x 5" x 3mm)
- stack multiple units to create extra depths - 1/4", 3/8", 1/2", 5/8", etc.
- inner opening 4.13" H x 4.25" W (4-1/8" x 4-1/4")
- adds border under double-gang Legrand screwless plate cover for two devices mounted panel up to fill gap
- sits around electrical box, held in place by friction when plate is installed over it
- note that Legrand plates have a reverse beveled edge so ring aligns with subplate
- Kyle Switch Plates exclusive item
- gloss acrylic, clean with warm water
- use a goof ring and screw spacers for mounting devices protruding from box
- for use on flat surfaces only; sand wall to remove bumps
- do not bend or item may crack
- WARNING: for indoor decorative use only. Ensure devices are properly installed in box.
- Important: if using with protruding devices, must use fire safety box extenders and spacers to ensure devices are safely installed
- white hard plastic gaskets
- designed for use with 2-gang Legrand Radiant light plates
- Radiant Collection is a Pass & Seymour Legrand trademark
- made in USA
Uses
- Hide sides of standard electrical box in shallow wall
- Add an edge behind wall plate to hide bulky devices
