Description
These trimmed short 2 rocker Decora outlet covers are 3/16" shorter on one side than standard switchplates yet still have neat, beveled edges on all four sides. 2-gang shortie rocker switchplates for spacing problems on either the top or bottom of your electrical box where you have installed rocker switches, slide dimmers, GFCI receptacles, etc.
Uses
- stacked electrical boxes (flip with short sides top to bottom for the closest fit)
- wall boxes right next to the bottom of a cabinet
- boxes bumping up against the countertop or backsplash
- tiling or brick abutting the electric box
Features
- Kyle Switch Plates exclusive design
- 4-9/16" W x 4-1/2" H x 5/32" D with one trimmed side (top or bottom)
- finished beveled edges on all 4 sides
- Decora switch hole is 3/4" from edge of wallplate on one end; 1-1/8" from the other
- short end can be used on either the upper or lower side of cover
- 4 matching 1/2" screws
- similar to a 4" rocker switch wall plate but with full coverage on sides without obstructions
- device opening holds all rocker, GFCI, Dacora, block, slider fan control, and Decora style devices (Decora is a Leviton trademark term)
- metal rocker light plates made in USA
Installation Instructions: These specialty switch plates have screw holes set at box mount spacing (3.281") instead of standard strap mount (3.812") because of the edge trim. So when installing, use the same screw to go through both the plate then the device directly into the wall box.
Will it fit? Measure from the center of the screw that holds the device in the electrical box to the edge of the trim, cabinet, backsplash, etc. If it is 11/32" (8.7mm) or more, the switchplate will fit.
