Description
Swap out your older 4-pilot lighted GE low voltage control station on a 2-gang box with this Touchplate 8-button unit for an updated solution to dated-looking switches. These units are designed with four pairs of buttons that correspond to the two directions on the vintage GE mini rockers or the more-recently discontinued double square pushbutton switches where one button/one direction was ON, the other button/direction was OFF. Choose from white, ivory, or black for a stylish solution to refresh your existing low voltage set-up. Each switch station has four pairs of 1/2" square button caps.
ALL COLORS ARE SPECIAL ORDER WITH A 3-WEEK LEAD TIME; NO RETURNS/EXCHANGES
Features
- this 8-button unit is an alternative solution to replace a control station with four GE low voltage pilot light switches (that have GE RR9 pilot light relays connected to them)
- replaces four RS232P, RS237P, RS239P, RTS-8, RFS-8, RCS2PL, etc., switches in GE, Bryant, and Sierra systems
- note: RR9 pilot light relays are required to power the LED lights; please be sure you have the extra wiring and the RR9 pilot light relays installed
- note: all four relays connected to switch must be the same brand
- buttons are NOT engraved - order Classic engraved ON/OFF button caps separately if needed
- unit can be installed vertically or horizontally for boxes installed either direction - see 2-gang low voltage mounting rings if needed
- 2 wire switches easily adapted to a 3-wire system by doubling the number of buttons with pairs of ON/OFF buttons
- pilot lights with 4 green LED bulbs that illuminate when the connected loads are ON. (Other four LED lights on the OFF buttons will never light up.)
- 1 amp @ 28 volts switch contact rating
- 8 momentary contact switches (4 pairs); dry contact
- easy installation with the included free 3 wire to 2 wire low voltage conversion diagram
- 4-1/2" x 4-1/2" plastic screw-less wallplate
- two 2" x 1-9/16" switch cutouts
- 3-9/32" screw hole spacing center to center in metal yoke
- back depth is 5/8"; overall depth is 15/16" from front of button to back of terminal bar
- four 1" mounting screws
- white, black, or ivory
- American made
- note: The metal flanges on the cover post holes on vintage units are designed to be delicately pinched with pliers to get the right tightness to hold the covers on snugly.
Click Low Voltage Wiring System Replacement Devices for relays, transverter power supplies, and more switch options.
