Description
1/4 Inch Offset Narrow Rocker GFCI Outlet Wall Plate - White
This 1/4" trimmed half narrow decorator rocker light switch plate is skinnier on one side for fitting into a spot that's blocked by a cabinet or other obstruction that's sitting too close. If your DIY home improvement project had a miscalculation and a standard cover won't fit over your single-gang electrical box, check measurements to see if this cover with an offset rocker opening will fit.
Features
- American-made rocker / block outlet cover plate
- white enamel finish on .03" steel
- overall dimensions 2-3/4" W x 4-1/2" H x 5/32" D
- from center screw to edge of small side is 1-1/8" (.125")
- center screw to wider side is 1-5/8" (1.625")
- skinny edge may be installed on left or right (rotate plate however you need)
- 2 white 5/16" mounting screws included
- device cutout is standard rocker with top and bottom screw holes - only difference is that one side of cover is thinner
- not available in plastic
- paintable
- openings designed for GFCI receptacles, block outlets, rocker ceiling fan controls, Decora dimmers and switches. ("Decora" is a Leviton trademark.)
Shop narrow wall switch plates - other widths available.
