Description
Oversized Wider Double Toggle Light Switch Wall Plate Cover for Two Boxes
This two-gang large toggle switchplate is designed for covering 2 toggle switches or dimmers that are spaced farther apart, typically because two single boxes were mounted side-by-side instead of using a standard 2-gang box. Clean and attractive, you'll want to show off these high quality toggle switch plates with their crisply beveled edges.
- SPECIAL SCREW SPACING: Distance between horizontal screws is 2.25" on centers
- note switches have a little wiggle room for slight adjustments
- jumbo 5-1/2" W x 5-1/2" H x 5/32" D
- 4 matching 1/2" installation screws
- made in USA
- white baked enameled finish on steel
Need a smaller version with the same spacing? See the Wide-Spread 2 Toggle Switch Wall Plate for Dual Boxes - White.
INSTALLATION NOTES
When adjusting spacing, turn off the electricity to the devices, loosen switch screws, push toggles slightly until they line up with the plate openings. Tighten screws again and install the cover. Restore the power.
